This is a great looking case. Infact there isn't any that can compete, although if I were to compete with this there's a lot of things I would change.
The case smells of the adhesive they use to adhere the lining with, so the wii and everything else ends up smelling like the glue, which is quite strong.
The spaces weren't thought out enough. Of course the upper left spot is for the wii, and under it is for the stand. What they forgot is that the stand isn't 90 degrees on both sides, it is slanted so it barely fits. The velcro isn't measured right, it is too long to hold the wii down properly, I ended up cutting it. Another thing is that the space for the wii is so tight that it is hard to get it out. They should have put a ribbon of some sort under it like there are in some battery compartments to get the wii out. If you have 4 wiimotes AND 4 nunchuks good luck getting all of them to fit on the right side. The top two compartments on the right side don't even fit 2 wiimotes snugly, the measurement is okay left to right but there's wasted space if you are using it for the wiimotes. And there's only room in the upper compartment for 4 games. A better idea is if you were to put the 4 wiimotes in the game section, and put all your games into a wii game wallet on the right side. They should have just put a game wallet up there to begin with. Another thing that is forgotten about is the power brick. It doesn't really fit anywhere. It fits diagonally in the bottom right box but you have to really shove the rest of the cord attached to it down there. The only thing that really has a spot is the sensor bar, and it goes right above the spots for the game and it fits perfectly there, and then the wire can just dangle in between where the spaces for the games are supposed to be.
They should have included a picture of what the heck they were thinking about putting into the different slots. It seems they just ended up putting this case together as fast as possible and didn't really think out the sections.
But then again, intec is the only company who makes these cases in aluminum, so on the outside it looks cool, but other than that, before I bought the game wallet to go in there it took me forever to get 4 wiimotes and 2 nunchucks with 5+ games, as well as bringing both the component and standard composite cables. I like the outside but I wouldn't dare before try to show anyone the inside.
Was this review helpful to you? Yes/No - You may also flag this review.