This holster works very well for the rather unusually shaped VX8700, once you figure out how to use it. At first I thought it did not fit the phone at all. However, it turns out you have to place the phone into the holster face-in instead of the usual face-out.
Once I realized this (a few hours of fuming after my initial attempt) it holstered marvelously. You wouldn't think documentation would be necessary for such a simple device, but in this case a note letting folks know to install the phone face-in would have been a good idea as I've never seen another holster like this. That's really the reason I'm writing this review, to inform folks.
Obviously, because of this, the phone must be removed from the holster to be used (unlike some holsters for clamshell phones). In every other way, I like this holster very much. The VX8700 fits securely but is easy to remove. The holster is able to rotate 90 degrees relative to the clip in both directions. The clip itself cannot handle two layers of my thickest belt very well, so I had to switch it to my right side where the belt is one layer.
Was this review helpful to you? Yes/No - You may also flag this review.