Ideal Linkmaster Pro Tester - 1 X Rj-45 Network , 1 X Rj-45 Network Remote - Network Testing Device (62200) (62-200)

(No reviews yet) Write a Review
Usually ships the same or next business day. In stock at our OK warehouse.
Calculated at Checkout
Stock Update:
05/24/2023 03:45:34 PM PST

Bulk discount rates

Below are the available bulk discount rates for each individual item when you purchase a certain amount

Buy 2 and pay only $86.63 each 86.63
Buy 3 - 4 and pay only $84.40 each 84.4
Buy 5 - 9 and pay only $82.62 each 82.62
Buy 10 - 13 and pay only $81.28 each 81.28
Buy 14 or above and pay only $79.94 each 79.94
Stock Update:
05/24/2023 03:45:34 PM PST


This item is brand-new, factory sealed.

  • LED-based basic wiremapper verifies cable continuity
  • &bull
  • Identifies errors by pair--shorts, opens, miswires, reversals, and split pairs
  • &bull
  • Tests for shield continuity
  • &bull
  • Designed for CAT 3/5/5E/6/6A cables
  • &bull
  • RJ45 interface for 8-conductor twisted pair cables
  • &bull
  • Debug feature cycles through errors one at a time
  • &bull
  • LED green/red lights helps pass/fail visibility in darker locations
  • &bull
  • Includes main unit and remote for 1-person testing
  • Features




    Physical Characteristics
    Weight (Approximate)2 lb
    Network (RJ-45)Yes
    Number of Network (RJ-45) Ports2
    Status Indicators<ul><li>Battery low LED</li><li>OPEN - There is no "OPEN" LED indication. A typical cable may have 2, 3, or 4 pairs. OPENS are displayed as an unlit LED. The user will determine if a pair is present and continuous or OPEN by comparing the illuminated LEDs to the expected number of pairs that should be good. For example, when testing a 4 pair cable, three illuminated LEDs in the PASS area indicate the presence of an OPEN condition in one of the pairs</li><li>SHORT - A short circuit condition exists</li><li>MISWIRE - Indicates the improper assignment of individual wire pairs to pins for the wiring schemes tested. Tester checks T568A, T568B, 10Base-T, and Token Ring configurations</li><li>REVERSAL - Reverse wiring means the pin for one wire in a pair is connected to the opposite pin for the pair in the remote jack</li><li>SPLITPAIRS - Split Pairs occur when the tip (positive conductor) and ring (negative conductor) of two twisted pairs are interchanged</li></ul><p><b>Pass Indicators:</b></p><ul><li>T568A and T568B</li><li>Four green LEDs on pairs 1-2, 3-6, 4-5, and 7-8. All four pairs are terminated correctly</li></ul><ul><li>Token Ring</li><li>Two green LEDs on pairs 3-6, and 4-5. Both pairs terminated correctly</li></ul><ul><li>10 Base-T</li><li>Two green LEDs on pairs 1-2, and 3-6. Both pairs terminated correctly</li></ul><ul><li>Shield</li><li>Green SHIELD LED indicates the shield on the cable is correctly and continuously wired through the modular plug termination</li></ul><p><b>FAIL Indicators:</b></p><ul><li>A flashing pair LED indicates that this wire pair has a fault. A flashing LED in the FAIL section will indicate which fault was detected. Multiple flashing LEDs indicate multiple pairs and/or multiple faults. Best practice is to correct cable faults until cable is verified as correct with appropriate green LEDs</li></ul>
    Battery Information
    Battery Size SupportedAA
    General Information
    Brand NameIDEAL
    Manufacturer Website Address
    Marketing InformationThe LinkMaster PRO Tester enables installers,contractors and maintenance technicians to map, test and troubleshoot data and voice communication cable and coax runs. Rugged, versatile, and easy-to-use, the LinkMaster PRO tester has mastered the link between performance, simplicity and value for both commercial and residential applications.
    Product TypeNetwork Testing Device
    Product NameLinkMaster PRO Tester
    ManufacturerIDEAL Industries, Inc
    Manufacturer Part Number62-200
    Product LineLinkMaster PRO
    Technical Information
    Minimum Length Measurement3 ft
    Maximum Length Measurement600 ft
    Device Function

  • View AllClose

    Warranty Information

    All Items are Brand New, Factory Sealed and come with a standard warranty. [Read our policies]
    View AllClose

    0 Reviews

    View AllClose
    Ideal Linkmaster Pro Tester - 1 X Rj-45 Network , 1 X Rj-45 Network Remote - Network Testing Device (62200) (62-200)