Bearing Pullers

This item is brand-new, factory sealed. Use to remove differential side carrier bearing. Works on a wide variety of cars and light-duty trucks. Includes four step plate adapters to fit carrier bearings. Reach: 1-5/8. Spread: 2-5/8 to 3-3/8. Set...

This item is brand-new, factory sealed.Features and Benefits: 2 Forcing Screws (Live Center): 3/4"-16 x 6-11/16" and 3/4"-16 x 5"2 Cross-bar Yokes: 3 pin-hole at 3-1/4" to 5-1/2", 2 pin-hole at 2-3/8" to 3-3/8" 2 Clamp Bolts3 Pairs of Puller Jaws:...

This item is brand-new, factory sealed.Features and Benefits: Operates on many models with engine in chassisPilot bearing pullerWeight: 3 lb., 7 oz.Designed to Pull Flywheel Pilot Bearings in Close Quarters Where a Slide Hammer Cannot be Used. Operates...

This item is brand-new, factory sealed.Features and Benefits: Fits minimum bearing tube I.D. of 1-5/16" Maximum axle tube I.D. of 2-3/8" Redesigned to make the removal of semi-floating rear axle bearings easier Makes short work...

This item is brand-new, factory sealed.OTC (7497A) Rear Axle Bearing Puller Rear axle bearing puller Fits minimum bearing tube I.D. of 1-3/8 inch and a maximum axle tube I.D. of 2-7/8 inch Brand: OTC Model: 7497A Item Weight: 12.8 ounces Product...

This item is brand-new, factory sealed.Features and Benefits: Necessary for pulling and installing bearings, gears or other parts found on hollow shafts or housings May be used with Grip-O-Matic® pullers and Push-Pullers as well as shop...

This item is brand-new, factory sealed.Features and Benefits: Built especially for inside pulling jobs, and particularly for removing flywheel pilot bearings on automobiles, trucks and tractors Also very practical for pulling motor, generator,...

This item is brand-new, factory sealed.Features and Benefits: Removes pilot bearings, thrust washers, small bearings hidden in a shaft or housing Min/Max Reach is 1/8" to 1" Jaws require a minimum of 5/8" opening and can range...

This item is brand-new, factory sealed.Features and Benefits Set provides proper size driver for nearly all automotive seal, bearing, or bushing installation jobs Includes discs, handles, spacers and drivers Range of 5/8" to 2"...

This item is brand-new, factory sealed.Features and Benefits: Splitter halves made of forged steel with sharp angled edges to get in between tightly assembled part Splitter halves include threaded holes for the acceptance of pushing/pulling...