Permatex
High Strength Threadlocker Red Gel Squeeze, 5 Gram Gel Squeeze Applicator Blister Carded 27005CAN
- SKU:
- 18043725
- MPN:
- 27005-can
- Availability:
- Usually ships the same or next business day. In stock at our GA, PA warehouses.
- Shipping:
- Calculated at Checkout
- Stock Update:
- 05/25/2026 11:57:07 PM PST
Bulk discount rates
Below are the available bulk discount rates for each individual item when you purchase a certain amount
| Buy 2 | and pay only $12.51 each 12.51 |
| Buy 3 | and pay only $10.89 each 10.89 |
| Buy 4 | and pay only $10.08 each 10.08 |
| Buy 5 - 9 | and pay only $9.27 each 9.27 |
| Buy 10 or above | and pay only $8.11 each 8.11 |
- Stock Update:
- 05/25/2026 11:57:07 PM PST
Description
This item is brand-new, factory sealed.
High Strength Threadlocker RED Gel Squeeze
OEM specified. Gel formula provides “liquid-reliability” without drips, globs, mess or waste. Available in three convenient sizes, the GEL TWIST™ pin-point applicator, the GEL SQUEEZE™ applicator, or the single-use pouch puts the Threadlocker right where you want it…on the part! High strength threadlocker for heavy-duty applications 3/8 inch to 1 inch (10mm to 25mm). Especially well-suited for permanently locking studs and press fits. Adds 3,000 PSI holding power on slip and press fit assemblies. Replaces set screws and snap rings. Locks against vibration loosening. May require heat or special tools for removal. Conforms to ASTM D5363 AN0221 (Mil-S-46163A, Type I, Grade K).
Applications:
- Automobile - Suggested Applications: Cylinder block and rocker arm studs, ring gear bolts, frame bolts, shock absorber bolts; also ideal for vertical applications
- Heavy Duty - Suggested Applications: Cap screws and mounting studs on differentials
Directions:
Parts should be clean and oil free.
- Remove protective cap.
- Turn dial to expose 1/8″ to 1/4″ of material beyond tip.
- Apply threadlocker to leading edge of male fitting,covering 5 to 6 threads. Avoid direct contact of tip to metal surface*.
- Assemble parts and tighten to recommended torque.
- Replace protective cap.*If contact occurs, expose 1/16” of material and wipe off with a clean towel.Temperature range: -65°F to 300°F (-54°C to 150°C).Refer to Technical Data Sheet for complete information.
NOTE: Permatex® Threadlocker Gel should not be used on plastic fittings. Do not use on food contact surfaces.Avoid food contamination during use and storage.
Warranty Information
