Permatex
Permatex Inc 27100-CAN High Strength Threadlocker Red, 6ml Tube Carded
- SKU:
- 18098800
- MPN:
- 27100-can
- Availability:
- Usually ships the same or next business day. In stock at our GA, KS, MI, PA, TX warehouses.
- Shipping:
- Calculated at Checkout
- Stock Update:
- 04/18/2024 09:30:04 AM PST
Bulk discount rates
Below are the available bulk discount rates for each individual item when you purchase a certain amount
Buy 2 | and pay only $9.92 each 9.92 |
Buy 3 | and pay only $8.34 each 8.34 |
Buy 4 | and pay only $7.56 each 7.56 |
Buy 5 - 9 | and pay only $7.08 each 7.08 |
Buy 10 or above | and pay only $5.52 each 5.52 |
- Stock Update:
- 04/18/2024 09:30:04 AM PST
Description
This item is brand-new, factory sealed.
High Strength Threadlocker RED Gel Tube - 6ml
OEM specified. High strength threadlocker for heavy-duty applications 3/8 inch to 1 inch (10mm to 25mm). Especially well-suited for permanently locking studs and press fits. Adds 3,000 PSI holding power on slip and press fit assemblies. Replaces set screws and snap rings. Locks against vibration loosening. May require heat or special tools for removal. Conforms to ASTM D5363 AN0221 (Mil-S- 46163A, Type I, Grade K).
Applications:
Automobile - Suggested Applications: Headlight screws, console assemblies, soundproofing, attachment screws, electrical component boxes, plastic knobs, hose fasteners, dashboard accessories, etc.
Motorcycle - Suggested Applications: All engine mounting bolts
Heavy Duty - Suggested Applications: Air starter fasteners, suspension fasteners, shock absorber mounts, wheel studs, exhaust system mounts, bumper fasteners
Marine - Suggested Applications: Cylinder block studs, ring gear bolts, frame bolts, shock bolts
Directions:
- Clean and dry parts using Permatex® Surface Prep™ activator, Item# 24163
- Shake tube ofHigh Strength Threadlocker well before each use.
- Remove cap and snip nozzle tip.
- Apply to threadedareas and assemble parts. Refer to Technical Data Sheet for complete information.
NOTE: Threadlocker works on metal parts. It is not recommended for plastics. Cured product must be heatedto 500°F (260°C) before parts will separate.