Permatex Inc 84160-CAN 1 Minute General Purpose Epoxy Clear, 0.84 Fluid Ounce Dual Syringe Carded

This item is brand-new, factory sealed.

1 Minute General Purpose Gel Epoxy - .84oz

General Purpose 1 Minute Gel Epoxy is a fast setting, two-part adhesive and filler system specially formulated with a Blue Dye Indicator that disappears when it’s fully mixed and ready to use. The advanced gel formulation reduces mess and waste compared to traditional epoxies; unique indicator system takes the guesswork out of “ready to use”.

Features:

• Non-drip formula allows for mess free application
• Can easily be applied to overhead and hard to reach places
• Sets in just 1 minute/Cures in 5 minutes
• Blue dye indicator disappears when epoxy is ready to apply
• No clamping required
• Bonds to metals, hard plastics, ceramics, and more!

Applications:

• Automobile - Suggested Applications: Ideal for complex, multi-piece assemblies. Bonds rigid materials including, ceramic, chrome, fabric, fiberglass, glass, hard plastic, and metal and rubber.

Directions:

1. PROTECT: Work area must be protected from accidental spills.
2. CLEAN: Surfaces must be clean, dry and free of grease and oil.
3. PREPARE: Roughen smooth surfaces (using abrasives or sandpaper).
4. OPEN PACKAGE: Remove Syringe. Turn syringe nozzle end up and pull plunger back slightly (1/8”). Allow air bubbles to rise to top. Snap off and save storage cap. Push plunger to dispense equal amounts of hardener and resin onto discard-able surface such as a piece of cardboard. Mixing paddle will pop out from plunger. Pull back plunger tostop flow. Snap cap back on.
5. MIX QUICKLY: Quickly and thoroughly mix until blue color turns clear (about 15 sec).
6.  APPLICATION: Apply small amount of mixture to both surfaces and assemble parts immediately (product sets in approximately 60 seconds). Remove any excess epoxy immediately.
7. CURE TIME: Usable strength is reached in 1 hour at 72ºF (22ºC).Cooler temperatures may require longer set time.
8. CLEAN-UP: Attach nozzle cap and store in molded tray.

NOTE: Adhesive will not bond most polyethylene or polypropylene plastics.