Tripp Lite series B110-SPPOEC-J12 In-Line PoE++ Surge Protector

This item is brand-new, factory sealed.

• Features | 2U In-Line Surge Protector Keeps Your PoE Equipment Safe Ideal for home/corporate IP security/building cameras, wireless access points, network switches and other appropriate network/PoE
• Just connect it between your source, such as an Ethernet switch, and up to 12 PoE devices using Cat5e/6 cables
• The 2U rack panel streamlines circuit protector placement for your entire system, typically located in the rear of a 19-inch rack for input/output lines
• Your Last Defense Against Intruding Voltage Spikes Solid-state silicon-avalanche diode technology features low clamping voltage, providing superior protection against ESD and super-fast response
• Both mid-span and end-span PoE are supported

• Product Dimensions: 1 x 19 x 4 inches

Features | 2U In-Line Surge Protector Keeps Your PoE Equipment Safe Ideal for home/corporate IP security/building cameras, wireless access points, network switches and other appropriate network/PoE devices, the B110-SPPOEC-J12 protects connected Power over Ethernet (PoE) equipment from damage caused by electrostatic discharge (ESD) and power surges. Just connect it between your source, such as an Ethernet switch, and up to 12 PoE devices using Cat5e/6 cables. The 2U rack panel streamlines circuit protector placement for your entire system, typically located in the rear of a 19-inch rack for input/output lines. Your Last Defense Against Intruding Voltage Spikes Solid-state silicon-avalanche diode technology features low clamping voltage, providing superior protection against ESD and super-fast response time under one nanosecond. Both mid-span and end-span PoE are supported. The B110-SPPOEC-J12 meets the following IEC/EN regulations: IEC 61000-4-2 for ESD (8k/15kV), IEC 61000-4-4 for EFT (2kV, 5KHz/100KHz) and IEC 61000-4-5 for (2KA 8/20s, 6KV 8/20s). Ready to Use Right from the Package, So You Can Plug and Play Immediately This PoE++ in-line surge protector meets 802.3af, 802.3at and 802.3bt Type 4 IEEE standards, while supporting data transmission speeds up to 10 Gbps. No software or external power supply is required. The compact metal housing is designed to endure in applications where static discharge is likely to occur. Mounting hardware is included for convenient rack installation in 2U of space. TAA-Compliant for GSA Schedule Purchases The B110-SPPOEC-J12 is compliant with the Federal Trade Agreements Act (TAA), which makes it eligible for GSA (General Services Administration) Schedule and other federal procurement contracts.

• B110-SPPOEC-J12 In-Line PoE++ Surge Protector
• Grounding Wire, 1 ft. (0.3 m)
• Grounding Wire Screw
• 4 x Rack-mounting Screws
• Installation instructions